Active PoE

USB converter serve to powering any device by USB port. Its converting 802.3af PoE to 5V/2A with 10W maximum load. Example of installation Important note: converter does not convert data from Ethernet to USB, but only power

Outdoor PoE extractor for powering most RouterBOARDs or Ubiquiti devices. It is a converter from active power supply designated as 802.3af to passive PoE 18V/0.7A with a maximum load of 12.8W.

MaxLink MAXPI15FE is a very simple 100Mbps PoE injector with one output POE port to power devices with 802.3af support with maximum consumption up to 24W, output voltage 48V and current 0.5A. The ma

Cable extender equipped with TransPort connectors is intended for coupling UISP TransPort cables in outdoor. Mounting is possible to the mast / pole with diameter 35mm - 60mm.

The Huawei AD-560062T0E is a Gigabit POE injector with one output POE port for powering devices supporting 802.3af/at with a maximum consumption of up to 35W. The power injector is suitable especially for powering APs, IP cameras, VoIP phones, etc.

TP-Link POE10E PoE extends a PoE/PoE+ network connection an additional 100 m/250 m (10 Mbps mode) from the PoE power sourcing equipment. Supplies up to 20W, which meets the power consumption requirements of most IP cameras.

MaxLink PI60-10G is a high-quality 10-Gigabit PoE injector with a single output PoE port for powering devices that support 802.3af/at standards with a maximum power consumption of up to 60W. To ensure better distribution of the current load, power is s

MaxLink PI60 2x2 is a dual-port PoE injector designed for indoor use. It provides 55 VDC power for remote PDs through one PoE port or delivers 30W per port for two remote PDs simultaneously. It powers terminal devices that support the IEEE802.3af/at st

POE-PAN4-GB-AF/A is a Gigabit active PoE injector that is suitable for powering up to 4 devices, such as IP cameras, VoIP or other devices with support for 802.3af/at standards with a maximum power consumption of 30 W. Ethernet por

POE-PAN4-GB-AF/A is a Gigabit active PoE injector that is suitable for powering up to 4 devices, such as IP cameras, VoIP or other devices with support for 802.3af/at standards with a maximum power consumption of 30 W. Ethernet por

With this adapter, you can power Raspberry PI (all models), other single-board computers, and other devices powered by the Micro USB connector. This allows you to use these devices very flexibly and we don't need a power outlet or AC adapter. T

MaxLink PI60 EXT 1x2 is an industrial PoE extender with three 10/100/1000 Mbps ports, 1x PoE-in port supporting 802.3bt/PoE++ with a power output of 60W or higher, up to a maximum of 95W and 2x PoE-out ports providing up to 30W each with

The Omada 10G PoE++ injector allows you to transmit data and power your devices with a single cable. It includes 1 LAN port with 10Gbps speed as output with PoE and 1 LAN port with 10Gbps speed for input connection. It is fully compliant with 802.3bt/a

A pair of extenders that allow you to extend PoE over twisted pair or coaxial cables. This solution is ideal for situations where replacing the original cabling is not an option. Each extender features a 1x 10/100 Mbit ETH port and a two-pin con

Product description prepares.

Product description prepares.