The wireless wire offers blazing fast Gigabit speeds for transparent connectivity between two locations, without any sacrifice in your LAN speeds. Simply point the included devices at one another and power them on, they are already preconfigured

This unique module opens up a whole world of high speed connectivity possibilities, offering up to 10 Gbps speeds over regular familiar twisted-pair cables in your existing products that have SFP+ ports. Any MikroTik device that has SFP+ ports can now

The S-55DLC80D is a singlemode Gigabit SFP module with a 1550nm wavelength, two LC connectors and maximum distance up to 80km. The module iscompatible with all MikroTik products, that have SFP or SFP+ cages and other cisco compliant devices.

The CRS328-4C-20S-4S+RM is a 28 independent port switch with a combo group. This device has twenty SFP ports, four SFP+ ports for 10G modules and four combo ports, where you can choose to use SFP or RJ45 ports from the combo group. These ports can also

The quickMOUNT is a basic wall mount adapter for small point to point and sector antennas. You can mount it on the wall or use it as an adapter from large diameter pole to small size antenna mounting clip ensuring reliable fitment. The quickMOUNT gives

RBmAPL-2nD is the smallest wireless Access Point with full RouterOS support and a built-in 2.4GHz radio part with support for 802.11b/g/n standards. The whole device is barely bigger than a matchbox and a special ethernet port was used to make i

The hAP ac is a Dual-band Access Point, that provides Wifi coverage for 2.4GHz and 5GHz frequencies at the same time. This router is equipped with 5 Gigabit LAN ports and 1 SFP port. The device is very small and will look good in a

CRS106-1C-5S is very small, cheap optical switch/router with RouterOS operating system, which includes 5x SFP and 1x combo (SFP / ETH) port. Cloud Router Switch is powered by QCA8511 processor clocked at 400MHz, includes 128MB of RAM

The new RB1100AHx4 Dude Edition uses a new quad core Cortex A15 chip from Annapurna labs, an Amazon company. The chip is clocked at 1.4GHz, for a maximum throughput of up to 7.5Gbit. The RB1100AHx4 Dude Edition supports IPsec hardware

CA411-711 is new indoor case for RB411, RB911, RB912 and RB922 series. It has changeable front panels, so you can choose one that fits the product that you actually use. Also, case is higher to accommodate high-power wireless cards and has wall mountin

It reduces wind load, protects reflector surfaces from harsh environment, protects the antenna feed from falling objects, as well as positively affects the antenna sustainability and operational life. It's made from a special material that has a low di

mANT30 is a professional class 5 GHz 30dBi dish antenna, built to the highest industry standards. Built to seamlessly accomodate our Basebox series products, but can be used for any pole mounted wireless device due to the adequate length of the include

R11e-5HacD is our new 802.11ac card in miniPCI-express format, perfect for any RouterBOARD with miniPCIe slot, such as RB953, RB912, RB922, RB800 or x86 devices with RouterOS. The card features built-in LED indicators for wireless mode, conne

RouterBOARD RB922UAGS-5HPacD is a very versatile wireless router, perfect for assembling your own solution. It supports the new 802.11ac standard for high speed wireless (up to 866Mbit datarate and 20/40/80MHz channels). The device has ports and slots

The RB750r2 (hEX lite) is a small five port ethernet router in a nice plastic case. Its price is lower than the RouterOS license alone - there simply is no choice when it comes to managing your wired home network, the RB750r2 (hEX lite) has it all.

The RB912 in an outdoor enclosure, fit with two RPSMA connectors for antennas, and a cable hood for protection against moisture. Also available are three additional places for antenna connectors, in case you wish to use the RB912 miniPCIe slot for one

ACGPSA is standalone active GPS antenna, that works in 1575.4 MHz spectrum. Antenna size is 46.5mm x 26.5mm x 12.5mm with IP67 rating and includes internal magnet and double sided tape, so it can easily be attached to various surfaces. It

The CRS305 is a compact yet very powerful switch, featuring four SFP+ ports, for up to 10 Gbit per port. The device has a 1 Gbit copper ethernet port for management access and two DC jacks for power redundancy. The device is a very sleek and compact me

The CRS309-1G-8S+ is a very compact, yet powerful networking switch. It has eight SFP+ slots, supporting up to 10 Gbit module in each, which results in a total switching capacity of 162 Gbps and total non-blocking throughput of 81 Gbps

48V 2A 96W power supply, to be used with MikroTik products that support 48V POE output, like hEX PoE and CRS112-8P-4S-IN. It’s providing 30% more current than the old model 48POW (48V 1.46A 70W), allowing more power per port. Co

A small package with a huge ambition – the wAP ac LTE6 is an extremely cost-effective dual-band (2.4 / 5 GHz) home access point based on our popular weatherproof wAP form factor. It has two Gigabit Ethernet ports – you can use the device

If you are looking for a single switch that will put your network setup ahead of the curve without costing a fortune, look no further. The new CRS354-48G-4S+2Q+RM is an effective and adaptable rackmount solution for managing networks in demanding and b

Chateau LTE6 is a Dual Band home WiFi router with 5x Gigabit LAN ports and LTE category 6 modem included one USB port and a micro SIM card slot. The wireless part of 2.4 GHz provides modulation speed 300 Mbps

XQ+31LC10D is a Singlemode QSFP28 module with a maximum throughput of 100 Gbps, 4 channels, wavelengths 1296 nm, 1300 nm, 1305 nm, 1309 nm and with two LC connectors for connection up to a distance of 10 km. T

MikroTik Cloud Router Switch CRS518-16XS-2XQ-RM is a feature-packed backbone switch for your network and features 2× QSFP28 (100 Gbps), 16× SFP28 (1/10/25 Gbps), one 10/100Mbps metal port intended

LHG LTE18 kit is a device used to connect to a mobile 3G/LTE network. Place it outside on a pole or anywhere high enough and connect where there are no cell phones. Thanks to the large, high-gain antenna, the device can connect to transmitters e

nRayAIM-DH1 is an alignment and aiming attachment for the nRAY. Use it to attach a scope of your choice for even greater precision and easier installation of the Wireless Wire nRAY. *Scope is not included.

We are releasing new direct attach cables that support not only SFP 1G and SFP+ 10G, but also the 25G SFP28 standard! With the new direct attach cables you get more features for the same price! This is highly cost-effective way

Professional high-frequency SMASMA cable from MikroTik designed for use in the LTE industry, for example for connecting LTE CPE unit and an LTE antenna. The 1m cable is terminated with two SMA male connectors. For better protection agains

XS+31LC10D is a singlemode SFP / SFP+ / SFP28 module with a maximum throughput of 25 Gbps, supporting lower speeds of 1 Gbps and 10 Gbps with, wavelength of 1310nm and two LC connectors for connection up to a distance of 10km